A novel method of the separation/preconcentration and determination of trace molybdenum(VI) in water samples using microcrystalline triphenylmethane loaded with salicyl fluorone

It is the first time that triphenylmethane was used as an adsorbent to preconcentrate and separate trace amount of molybdenum in water samples. The effects of different parameters, such as acidity, stirring time and various metal ions, the amounts of triphenylmethane and salicyl fluorine, etc. on the enrichment yield of molybdenum have been studied to optimize the experimental conditions. Under the optimum conditions, molybdenum can be adsorbed on the surface of microcrystalline triphenylmethane loaded with salicyl fluorone by the intermolecular action strength. The possible reaction mechanism for the enrichment of molybdenum was discussed in detail in this paper. Mo(VI) can be completely separated from Pb(II), Co(II), Cu(II), Cr(III), Ni(II), Hg(II), Zn(II), Cd(II), Fe(III) and Al(III) in the solution. The proposed method was successfully applied to the determination of trace amount of molybdenum in various water samples by spectrophotometry after preconcentration using microcrystalline triphenylmethane. The preconcentration factor is from 83 (500 ml water sample was enriched to 6.0 ml) to 166 (1000 ml water sample was enriched to 6.0 ml). The detection limit is 1.3 × 10⁻⁵ mg l⁻¹ and the linearity is maintained in the concentration range 3.8 × 10⁻³ to 0.36 mg l⁻¹ with a correlation coefficient of 0.9998. The recoveries are in the range of 93.5-104%. The relative standard deviation is 1.8-2.9%. Analytical results obtained with this novel method are very satisfactory.     

配合物[Li(THF)_2]_2(μ—Cl)_4[(η~5—CH_3C_5H_4)Nd·THF]的合成及其晶体结构

环戊二烯基希土氯化物是一类合成希土有机配合物的重要前身。尽管在1980年前没能成功地合成含轻希土元素的这类配合物,但目前已发现,采用具有较大体积的取代环戊二烯做配体,如C_5Me_5H,C_5H_3〔Si(CH_3)_3〕_2H,C_5Me_4C_3H_7H和桥联的配体(C_5H_4)_2(CH_2)_3H_2都可得到相应的取代环戊二烯基轻希土氯化物。控制LnCl_3和CpNa的反应摩尔比也可以成功地得到这类轻希土的环戊二烯基氯化物。     

万古霉素手性固定相分离曼尼希碱类化合物对映体

采用大环抗生素类万古霉素手性固定相高效液相色谱法研究了一系列曼尼希碱类化合物的手性分离情况,并讨论了流动相中有机相的种类和比例、缓冲盐的种类和浓度、pH和柱温对该类化合物手性分离的影响。最佳实验条件为:乙腈:硝酸铵(35mmol/L,pH3.8)=15∶85(V/V),柱温15℃,流速0.6mL/min,检测波长300nm;四氢呋喃:硝酸铵(20mmol/L,pH4)=15∶85(V/V),柱温15℃,流速0.6mL/min,检测波长350nm。通过对比研究8种曼尼希碱类化合物的色谱行为,从结构上讨论了化合物中各种官能团对手性分离的影响,并探讨了手性分离的内在机制。     

Solvation of acylium fragment ions in electrospray ionization quadrupole ion trap and Fourier transform ion cyclotron resonance mass spectrometry

In electrospray ionization (ESI) quadrupole ion trap and Fourier transform ion cyclotron resonance mass spectrometry, certain fragment ions (e.g. acylium ions) generated either during the ion transportation process (in the source interface region) or in the ion trap are found to undergo ion--molecule reactions with ESI solvent molecules (water, acetonitrile and aliphatic alcohols) to form adduct species. These unexpected solvated fragment ions severely complicate the interpretation of mass spectrometic data. High-resolution accurate mass measurements are important in establishing the elemental compositions of these adduct species and preventing erroneous data interpretation.     

PEO-LiClO_4-ZSM5 composite polymer electrolyte (IV): Polarized optical microscopy study

All solid-state lithium polymer batteries may be one of the best choices for the future electrochemical power source, characterized by high energy densities, good cyclability, reliability and safety[1,2]. Owing to its potential capability to replace the t…     

Linear response theory of ion excitation for Fourier transform mass spectrometry

A linear relation between the voltage density or magnitude spectrum of an excitation waveform and the corresponding ion orbital radius is derived for Fourier transform mass spectrometry (FTMS). This provides a theoretical foundation for the stored waveform inverse Fourier transform excitation method. The result is also useful for the design of optimal excitation signals as well as for the estimation of the kinetic energy of ions after an excitation event in collision-induced dissociation experiments. When the linear relation is applied to two-dimensional FTMS excitation, an analytical expression for ion speed modulation is obtained.     

Crystalline Morphology and Polymorphic Phase Transitions in Electrospun Nylon 6 Nanofibers

Uniform nylon 6 nanofibers with diameters around 200 nm were prepared by electrospinning. Polymorphic phase transitions and crystal orientation of nylon 6 in unconfined (i.e., as-electrospun) and a high T(g) (340 degrees C) polyimide confined nanofibers were studied. Similar to melt-spun nylon 6 fibers, electrospun nylon 6 nanofibers also exhibited predominant, meta-stable gamma crystalline form, and the gamma-crystal (chain) axes preferentially oriented parallel to the fiber axis. Upon annealing above 150 degrees C, gamma-form crystals gradually melted and recrystallized into the thermodynamically stable alpha-form crystals, which ultimately melted at 220 degrees C. Release of surface tension accompanied this melt-recrystallization process, as revealed by differential scanning calorimetry. For confined nanofibers, both the melt-recrystallization and surface tension release processes were substantially depressed; gamma-form crystals did not melt and recrystallize into alpha-form crystals until 210 degrees C, only 10 degrees C below the T(m) at 220 degrees C. After complete melting of nano-confined crystals at 240 degrees C and recrystallization at 100 degrees C, only alpha-form crystals oriented perpendicular to the nanofiber axis were obtained. In the polyimide-confined nanofibers, the Brill transition (from the monoclinic alpha-form to a high temperature monoclinic form) was observed at 180-190 degrees C, which was at least 20 degrees C higher than that in unconfined nylon 6 at approximately 160 degrees C. This, again, was attributed to the confinement effect.     

杂多酸的固载化Ⅲ.溶剂对H4Siw12O40.24H2O在活性炭上吸附的影响

研究了Ｈ４ＳｉＷ１２Ｏ４０．２４Ｈ２Ｏ（ＳｉＷ１２）在水，乙醇，乙酸，乙酸丁酯中在活性炭上的吸附得出，活性炭微孔结构对ＳｉＷ１２在其表面的吸附起着分子筛作用，水溶剂化的ＳｉＷ１２分子可顺利进行活性１．７ｎｍ左右的微孔，而其它溶剂化的ＳｉＷ１２分子，则需较大的孔径，提出了ＳｉＷ１２在活性炭表面吸附的微孔中孔扩散模型。     

聚碳酸酯改性聚酯型热塑性聚氨酯弹性体的合成与性能

以聚碳酸１，６－已二醇酯（ＰＣ）、聚己二酸－１，４－丁二醇酯（ＰＢＡＧ）、４，４－二苯基甲烷二异氰酸酯（ＭＤＩ）和１，４－丁二醇（ＢＤＯ）为原料，合成线型聚碳酸酯改性聚酯型热塑性聚氨酯弹性体（ＴＰＣＺＥ）．对其玻璃化转变温度Ｔｇ、力学性能、耐水解性能和流变特性进行了研究。实验结果表明：随ＰＣ二醇含量的增加，弹性体的贮能模量下降，Ｔｇ则向高温方向（从－７．８℃到＋２．６℃）移动。水解后的强度保持率从８５．４％提高到９９，７％和１１７％，熔体的表现粘度降低，加工性能得到改善。     

紫荆花红色素开发利用的研究

首次报道紫荆花红色素的提取纯化方法及红色素的理化性质，并与玫瑰茄红色素作对比研究，证实同属于花青甙类化合物，又经急性毒性试验证明其毒性极低，故紫荆花天然红色素具有开发利用的价值。